NOVELTY: UNIPUMP brass y-type strainers
Novelty in the group of component parts!
Such strainer is installed both in hot and cold water pipes. It is a brass unit with a separate mud collecting compartment with a mesh inside it.
What is this strainer designed for?
In course of time various deposits are accumulated in heating system coolant: particles of rust and scale. Such impurities clog the system and heaters, and reduce nominal pipe size.
Installation of such strainer allows intercepting various mechanical deposits significantly increasing service life of all system elements.
The same problem may also occur in cold water pipes: rust, sand and impurities clog pipes, automation and other devices.
How to select such strainer?
The greater water flow, the wider should be an offset-collector with a mesh. The strainer is installed with an offset downward. It is recommended to put a closing valve before a strainer to make mud removal easier. Then a check valve is installed to prevent the reverse water flow.
What models of strainers does UNIPUMP offer?
- 1/2", installed length - 550 mm
- 3/4", installed length - 700 mm
- 1", installed length - 750 mm
- 1 1/4", installed length - 950 mm